Carbide 3D Get a Grip Workholding Kit

• Carbide 3D Get a Grip Workholding Kit
• Includes Clamps, Claws, Stops, Corner Square Set, and more
• Offers twelve Teez-Nutz
• Comes with a very strong and very tough material
• Can be used on the Hybrid Table or attached to flat fixture plates
• Compatible with all Shapeoko 4, Pro, and HDM machines

The Carbide 3D Get a Grip Workholding Kit is compatible with all Shapeoko 4, Pro, and HDM machines using the included Teez-Nutz.

If you have a Shapeoko 3 or earlier, the clamps and corner square will work fine, but you'll need to provide T-nuts or other anchors for your table.

Note: The Essential Stops and the Essential Corner Square have a standoff molded into the base to put them slightly above the height of the MDF on a stock Hybrid Table. If you've taken a skim cut on your Hybrid Table then they may rest a little further above the MDF. This gap is OK. The standoffs allow the corner and stop to rest on the aluminum t-track for maximum rigidity.